#Should i detune my snowboard how to
Once you learn how to sharpen them up, you’ll never need to deal with dull ones again. Sharp edges on your snowboard make a world of difference. It also makes your riding much easier and a lot more fun. Learning how to do it yourself can save you money because you won’t have to go to the shop every time you need sharp edges. Once you have the necessary equipment, you can get the job done in a matter of minutes. Follow everything up with fresh wax if you need itĪs you can see, anyone can sharpen the edges of their board.Remember not to sharpen the tip and tail of your board.Repeat the process until both sides of your board have sharp edges.Reposition the file further up on the edge and repeat steps 6 through 8.Keep sharpening in the same area until the marker line you drew is no longer visible.Gently press down on the file and make long, smooth motions to begin sharpening the edges.You don’t want to go back-and-forth, as that can damage the edge. You use long motions from the tip to the tail of the board. Position the sharpener so it’s flat on the edge and the angle guide is in the proper place.This will be used as a guide to help you know which areas are sharp and where you need to sharpen again. Use the marker to draw a light line across the edge of your board.Most people use 90 degrees, but you may have a personal preference where you change that up and go a few degrees less. Adjust your guide to the proper angle.Lay board base up on your working surface.Take the bindings off of your snowboard.Set up a good workstation on a sturdy bench or table.As long as you get the angle right and never sharper the tip and tail, you’ll be fine.įollow these steps to sharpen the edges on your snowboard. Just note that you don’t need an extremely strong file to do a good job.
If you don’t, there are a lot of different snowboard tuning kits out there that you can purchase online. If you have all of the above tools, you can get started.
The outside edges were also hooking up in scary and dangerous ways. Just coming to a stop was a major effort in trying to avoid getting launched off the side of the trail. They were hooking up way too quickly and it was almost impossible to pull out of a turn. But instead they scared the crap out of me. Specs wise these skis should be everything I would love. I demoed a pair of Icelantic Rangers on Saturday. I'll admit I kind of blew off those comment thinking that they just weren't used to skiing nice, new skis with a good tune on them. It seems like many times they have reported back "I didn't like them, they were 'too grabby'". Over the years I've had lots of friends demo skis, but I haven't done many myself.
0 kommentar(er)
